DT SWISS 180 SPLINE 12mm CONVERSION KIT
CAMPESTRAL Race Face Turbine/Aeffect End Caps, combined with the extremely light weight CAMPESTRAL 12-15-TA Adapter, allow the use of a 15mm x 100mm Race Face Turbine or Aeffect wheel with a 12mm x 100mm thru axle Road/CX/Gravel fork.
There is a known compatibility issue with Race Face Turbine and Aeffect 15mm x 100mm hubs and 12mm Thru Axle forks, with no existing 12mm end cap available.
The end caps for Race Face Turbine and Aeffect 15mm x 100mm Thru Axle have an OD of 21mm at the fork interface end, which most 12mm forks will not accommodate.
CAMPESTRAL Race Face Turbine and Aeffect 12mm-Compatible 15mm end caps solve this problem.
Available as a complete kit including CAMPESTRAL 12-15-TA Adapter, or as end caps only for use with an existing axle adapter.
CAMPESTRAL RACE FACE TURBINE/AEFFECT END CAPS
- Compatible Race Face Part Number: F60018
- Press-in end caps convert 15x100mm front hub for use with 12x100mm fork axle.
DIRECTIONS:
1) Swap end caps: use your fingers or the CAMPESTRAL 12-15-TA adapter to gently pop end caps out of hub body.
2) Firmly press CAMPESTRAL 15mm End Caps into hub body.
2) Slide 12-15-TA Adapter into the 15mm hub.
3) Install wheel into fork as normal.
4) Install 12mm thru axle as normal.
NOTES:
- If the existing end caps do not “pop” off the axle easily the end cap O-ring may be dry and sticking. Put a few drops of TriFlow or similar lubricant around the edge of the end caps while turning and allow time for lubricant to reach O-ring. It may also be helpful to insert a 15TA axle or adapter to leverage the cap.
- A thin layer of grease on the O-rings inside the new CAMPESTRAL end caps is recommended.
- A thin layer of high quality grease on the outside of the adapter and the outside of the 12mm thru axle are recommended for ease of assembly and to provide an extra moisture barrier.
- Compatible with all 12mm x 100mm forks.
- Compatible with Race Face Turbine and Aeffect 15x100mm Thru Axle Hubs.
- Please note that the critical hub dimension for 12TA fork interfaces is the OD of the end cap, which must be 19mm or smaller. Stock DT Swiss 15TA end caps are 20-21mm and will not fit most 12TA forks.
- Thru axles provide compression of the fork ends where the hub end caps interface with the fork ends. Because all hubs and forks are manufactured by third parties to differing tolerances, to ensure an interference-free fit with all possible combinations the length of the CAMPESTRAL 12-15-TA Adapter is just under 100mm.